Laisimo L1 200 Watt Temperature Control Box Mod
From Laisimo the makers of the super popular Snow Wolf comes the L1 200W TC Mod. The Laisimo L1 has a maximum output power of 200W, and supports Nickel (Ni200), Titanium, and Stainless Steel wires in Temperature Control mode. The Laisimo L1 has a extra large 2.4" Color OLED Display to easily view all your settings and pertinent information.
The Laisimo L1 200W TC Box Mod has the ability to use Laisimo's L1 4.4app using Bluetooth 4.0 connectivity. (Only available for Android Phones) The Laisimo L1 Android App allows you to change your power or temperature settings with the "Mode" button on the Android App. You can control and limit your daily puff amount using the "Plan" button and also view detailed puff reports by using the "Record" button.
The Laisimo L1 200 Watt TC Mod uses (2) 18650 High Amp batteries (Sold Separately) which can easily be swapped with its magnetic battery door. The built-in Micro USB port allows you to download any future firmware updates.
Features & Specs :
Dimensions : 4" x 2" x 1"
Laisimo L1 Bluetooth Android App
Wattage Output : 5 - 200W
Voltage Output : 0.5 - 7.5v
Temperature Control Modes : Ni200 / Titanium / Stainless Steel
Temperature Control Range : 212 - 572F
Resistance Range : 0.05 - 2.5ohm (Kanthal, Ni200, Titanium, Stainless)
Battery Voltage : 6.2 - 8.4v
Requires (2) 18650 High Amp Batteries (Sold Separately)
Magnetic Battery Door
2.4" Color OLED Display
Micro USB Port for Firmware Updates ( USB Port is NOT for Charging)
Low Voltage Protection
Low Resistance Protection
Short Circuit Protection
High Input Voltage Warning
Over Heat Protection
Reverse Polarity Protection
***Temperature Control requires the use of Ni200, Titanium or Stainless Steel Wire/Coils***
Package Contents :
1 x Laisimo L1 200W TC Mod
1 x USB Cable
1 x Instruction Manual
30 day limited warranty against manufacturer defects. Scratches and discoloration to the finish, normal wear & tear, accidental damage etc... is not covered by warranty.
***The use of Nickel Ni200 or Titanium Ti coils should only be used on devices equipped with circuit boards capable of temperature control. The use of these coils on any other device could result in an explosion.***
This device should only be used with Lithium Ion IMR Batteries with an amp limit of 20A and higher. Using any other battery can be potentially dangerous.
Use special caution when working with any Li-ion cells as they are very sensitive to charging characteristics and may explode or burn if mishandled. Make sure the end user is very knowledgable of Li-Ion rechargeable batteries in charging, discharging and assembly before use. Always charge in/on a fire-proof surface. Never leave charging batteries unattended.
We are not responsible for any damage caused by misuse or mishandling of Li-Ion batteries and chargers.
LiteCigUSA will not be held liable for any personal injury and/or damage temporary or permanent caused from the use of this product.